Envalior · Grade
Durethan® BKV30H2.0
PA6-GF30
Manufacturer
Envalior
Trade family
Durethan®
Status
active
Technical properties
| Molding shrinkage, parallel | 0.3 % |
| Molding shrinkage, normal | 0.69 % |
| Tensile modulus | 9600 / 6000 MPa |
| Stress at break | 180 / 110 MPa |
| Strain at break | 3.6 / 7 % |
| Charpy impact strength, +23°C | 90 / 110 kJ/m² |
| Charpy impact strength, -30°C | 75 / 75 kJ/m² |
| Charpy notched impact strength, +23°C | 13 / 25 kJ/m² |
| Charpy notched impact strength, -30°C | 11 / 11 kJ/m² |
| Puncture - maximum force, +23°C | - / 1070 N |
| Puncture - maximum force, -30°C | - / 950 N |
| Puncture energy, +23°C | 14 / 8 J |
| Puncture energy, -30°C | 5 / 6 J |
| Melting temperature, 10°C/min | 220 °C |
| Temperature of deflection under load, 1.80 MPa | 205 °C |
| Temperature of deflection under load, 0.45 MPa | 220 °C |
| Coefficient of linear thermal expansion, parallel | 20 E-6/K |
| Coefficient of linear thermal expansion, normal | 70 E-6/K |
| Burning behavior at 1.5 mm nominal thickness | HB class |
| Thickness tested (Burning behavior at 1.5 mm nominal thickness) | 1.5 mm |
| Yellow card available (Burning behavior at 1.5 mm nominal thickness) | yes |
| Burning behavior at thickness h | HB class |
| Thickness tested (Burning behavior at thickness h) | 3 mm |
| Yellow card available (Burning behavior at thickness h) | yes |
| Oxygen index | 22 % |
| Relative permittivity, 100Hz | 4.2 / 12 |
| Relative permittivity, 1MHz | 3.8 / 4.4 |
| Dissipation factor, 100Hz | 100 / 2550 E-4 |
| Dissipation factor, 1MHz | 170 / 780 E-4 |
| Volume resistivity | 1E13 / 1E10 Ohm*m |
| Surface resistivity | - / 1E13 Ohm |
| Electric strength | 35 / 30 kV/mm |
| Comparative tracking index | 425 |
| Water absorption | 6.5 % |
| Humidity absorption | 2 % |
| Density | 1360 kg/m³ |
| Viscosity number | 140 cm³/g |
| Injection molding, melt temperature | 280 °C |
| Injection molding, mold temperature | 80 °C |
| Residual moisture content | 0.03 - 0.12% |
| Drying temperature dry air dryer | 80 °C |
| Drying time dry air dryer | 2 - 6 h |
| Melt temperature (Tmin - Tmax) | 270 - 290 °C |
| Mold temperature | 80 - 120 °C |
Indicative values. Always consult the manufacturer's official datasheet before specification.
Durethan® BKV30H2.0 equivalents
No verified equivalents indexed yet.
Typical applications
Injection Molding
Manufacturer
Envalior
Browse all indexed grades