MOCOM Compounds GmbH & Co. KG · Grade
ALFATER XL D50I 2GP0050
TPV
Manufacturer
MOCOM Compounds GmbH & Co. KG
Trade family
ALFATER XL
Status
active
Technical properties
| Base Polymer | Thermoplastic Vulcanisate (PP+EPDM) |
| Colour | black |
| Service Temperature | max. range (depending on load, geometry, etc.) -40-125 °C |
| Special Features | good recovery,good weathering resistance,good chemical resistance,good ozone reistance,good hot air resistance,good hydrolysis resistant,black fulfills weathering dry, hot (Kalahari, PV3929),black fulfills weathering moist, hot (Florida, PV3930) |
| Tear strength, parallel | 95 kN/m |
| Density | 970 kg/m³ |
| Pre-Drying Conditions | in a dry air (dessiccant) dryer 70-80 °C for 2-4 h max. moisture content <0,10 % |
| Processing Injection Moulding | melt temperature 200-240 °C mould temperature 10-70 °C injection speed high back pressure (hydraulic) >5 bar holding pressure 50-70% of injection pressure |
| Storage | dry, protected from light tightly sealed |
Indicative values. Always consult the manufacturer's official datasheet before specification.
ALFATER XL D50I 2GP0050 equivalents
No verified equivalents indexed yet.
Typical applications
Automotivebuilding and constructiondo-it-yourselfelectrical and electronicMachineryFurnitureinjection moulded partssealssealing liphandlesimpact protection / shock absorberprotection capscable ductscastersplugsfastener & connector2K components
Manufacturer
MOCOM Compounds GmbH & Co. KG
Browse all indexed grades